General Kart Rules

Frames

  

1. Any production/purpose build racing chassis.  Motor must be mounted on the side.

2. Frames must be constructed of metal.  No aluminum or conduit tubing.

3. All karts will be outfitted with roll cage.  Roll cage must be a minimum four-point either bolted or welded to frame.  Does not apply to flat karts.

4. Minimum of 3" head clearance to roll cage.

5. Minimum four-point seat belts bolted to frame or roll cage.

6. Front and rear bumpers are required.  Bumpers must be of tubular design.  No flat style allowed.  Maximum width of rear bumper may be no wider than tire sidewall width.  Maximum width of front bumper may be no wider than frame rails.  Lowest rail of bumpers may be no higher than 4" from the ground.

7. Nerf bars are required.  Nerf bars may not protrude past tire sidewall.

8. All karts must have adequate protection over drivers feet.

9. Wings on roof or front allowed.  Top wing sides must stay within 3" from outer most edge of kart.  No sharp edges.

10. All karts must run chain guards - no exceptions.

Weights

  

1. All weights added to kart must be bolted to point of attachment with adequate  fastener.

2. All weights must be painted white, so they can be seen if they fall from kart onto the track during the race.

3. All weights should have kart number on them for identification.


Drivers

  

1. All drivers must wear a DOT approved, full face safety helmet with complete eye protection.

2. All drivers are required to wear long sleeves and long pants.  A drivers suit is highly recommended buy not required for pump gasoline.  Drivers suite is required for alcohol fuel.

3. All drivers will wear an approved neck brace and arm restraints with no loose ends or they will NOT race.

4. Gloves are required.


Wheels & Brakes


 Any 5" or 6" diameter steel or aluminum wheels   


  

1. Mechanical or hydraulic disc is recommended.  No scrubber style brakes.  Must stop kart in a safe distance.

   

Kart Class Rules

Beginner Kart

TBA

Jr 1

Ages 5 – 8, weight 250# kart and driver,      AKRA Box Stock 6.5 HP Klone Style OHV Engine, must use restrictor plate      .425. 87 Octane gas only, approved      exhaust systems – AKRA Clones, WKA Briggs. Stamped steel drum shoe type clutches only. Open tire, wings optional. Trophy class 1st – 3rd.

Jr 3

Ages 8 – 12, weight 320# kart and      driver, unrestricted, open exhaust, all other same as Jr 1

Jr Yard

Ages 6 - 12 Factory rated up to 6.5 hp 4-cycle  max. May have any modifications to the motor. No alcohol. Any non-suspension production-racing or non production frame allowed. Frame must be made of steel, nor aluminum or exotic material. Bodies are mandatory. May resemble any production or race type      vehicle. Fiberglass, aluminum, plastic or steel. No suspension allowed. Wheel base 49” – 51”. Front and rear bumpers required. Not to exceed the outside tread width of tires. Max width overall kart not to exceed 45”. Nerf bars are required. No      sharp edges. Minimum 4 point roll      case must be securely welded to kart frame. Minimum 3” head clearance. Roll bar padding is advised. Cage must be constructed of steel no smaller than ¾”. No conduit cages.  All karts will have a kill switch within reach in front of driver. All karts will have a kill switch mounted at the rear of the kart for safety personnel. Minimum 5 point seat belt and arm restraints. Aluminum or plastic racing seat is recommended. Any aftermarket wheels are allowed. Max width 10 3/8”. Max diameter of 6”. Aluminum hubs and wheel spacers are allowed. Any turf tires or any type racing rubber allowed. Any compound, grooving is allowed. Disk type brakes are mandatory on rear axel, hydraulic brake system recommended. No scrubber or drum type brakes      allowed. Live axel only, no aluminum axles. Chain and sprocket guards recommended. Centrifugal clutch only. Factory rated up to 6.5 hp 4-cycle max. Any modifications allowed to a 6.5 hp factory rated block. Engine must be mounted in rear of kart. Stock blocks only. May deck block. Pump gasoline fuel only. No additives allowed. Stock tank allowed, custom tank must be vented away from engine. Quick release steering wheel. Trophy class 1st – 3rd.

Jr E-Class

Ages 6 -13  

  

If it does not specifically state that something is allowed, it is illegal.

This class is designed as a low cost racing venue. If you race in this class, you may not enter this kart in any other class.

Chasis: Any kart chassis allowed. 

Clutch: Any clutch #35 chains only.

Gearing: Open

Tires: Open

Fuel: Pump gas only. No methanol or additives allowed.

Engine: 5 hp flattop Briggs or 212cc Predator 

Exhaust: Open

Internal Engine Components: Must remain stock. THIS MEANS EVERYTHING.

Flywheel: ARC Flywheels (part #’s 6625-6626 only) allowed. No other flywheels will be allowed. This is for safety reasons.

Carb: Stock predator carb. Factory Choke and fuel cutoff switch must work.

On/Off Switch: May move to another location, but must be functional.

Gaskets/Insulators/Bearing/Seals: All must be stock. Stock single head gasket only. No copper or fire ring gaskets.

Oil: Any oil allowed.

Air Filter: Only stock air filter is allowed. No modifications.

Engine Starting: Must use stock pull start.

Karts: height can not exceed 4” off the ground, no plastic steering wheels, must be 1 tire fire and must have nerf bars on sides.

There will be a drawing at each riders meeting to determine which direction this class will run for that night.

Teen RWYB

Ages 13 to 16. Centrifugal clutch only. Trophy class 1st – 3rd 

Stock Predator

TBA

Adult Yard

Ages 14 and up. 

Same as Jr Yard

Adult RWYB

Ages 15 and up

Same as Teen RWYB

Adult E Class

Ages 14 & up.     

If it does not specifically state that something is allowed, it is illegal.

This class is designed as a low cost racing venue. If you race in this class, you may not enter this kart in any other class.

Chasis: 1 or 2 seater, 1 tire fire. 

Clutch: Any clutch #35 chains only.

Gearing: Open

Tires: Open

Fuel: Pump gas only. No methanol or additives allowed.

Engine: 5 hp flattop Briggs or 212cc Predator 

Exhaust: Open

Internal Engine Components: Must remain stock. THIS MEANS EVERYTHING.

Flywheel: ARC Flywheels (part #’s 6625-6626 only) allowed. No other flywheels will be allowed. This is for safety reasons.

Carb: Stock predator carb. Factory Choke and fuel cutoff switch must work.

On/Off Switch: May move to another location, but must be functional.

Gaskets/Insulators/Bearing/Seals: All must be stock. Stock single head gasket only. No copper or fire ring gaskets.

Oil: Any oil allowed.

Air Filter: Only stock air filter is allowed. No modifications.

Engine Starting: Must use stock pull start.

Karts: height can not exceed 4” off the ground, no plastic steering wheels, must be 1 tire fire and must have nerf bars on sides.

There will be a drawing at each riders meeting to determine which direction this class will run for that night.

Modified Flat

TBA

Pro Klone

Ages 15 and up, weight 350# kart and      driver, box stock 6.5 hp clone style OHV engine only, unrestricted, 87 octane gas only. Open header, open  clutch, slick tires only, no battle bars. Large zip-tie on spark plug wire with end pointing up is      recommended. Must be pull cord     started, no machining or grinding permitted. After market air filter and adapter is allowed. Timing and flywheel key is non-tech. Not stacked gaskets in      carburetor or between head and carb. 100% payback class.

500 Outlaw

Ages 15 and up, Single cylinder, single      carburetor or fuel injected two-cycle or four –cycle motorcycle or quad engine      not to exceed 550cc.. No slipper     clutches. Weight with driver shall be a minimum of 450#. Must run a treaded RR tire stamped 50 or 55 and must punch at a durometer reading of 50 or above. 100% payback class.